Altech Auto Security AL7024S - Manual (Page 15)

AL7024S Quick Start Manual
No. AL7020S-QSM-101 Altec Electronic AG Seite 15 / 18
3.8 SMS Commands
Command AT Manual pages Function
AT+CMGS Send message, p.178
Send SMS. Example:
AT+CMGS=”0764537865”<cr>
This is test SMS <ctrl-Z>
AT+CNMI
New message
indication, p.164
Example: AT+CNMI=2,1,0,0,0
Now, if an SMS is arriving, the following is displayed:
AT+CMTI: “SM”,2
Meaning: SMS was stored in location 2 of “SM”-
memory on SIM-Card. The memory used for
receiving SMS can be changed with the AT+CPMS
command. (see below)
AT+CMGR Read message, p.171
Read message from memory selected with
AT+CPMS command
Example: AT+CMGR=2 : read the second SMS in
memory
AT+CMGL List message, p.169
Read messages from memory selected with
AT+CPMS command.
Example:
AT+CMGL=”ALL” list all messages
AT+CMGL=”REC UNREAD” list unread received
msg.
There are more possible parameters for this
command
AT+CPMS
Preferred Message
Storage, p.160
The storage memory for messages can be selected.
Example: AT+CPMS=”SM” (“SM” being the most
usual mem.)
For a list of all possible memory areas see “AT
Commands Interface Guide”, p.70 (AT+CPBS
command)
AT+CMGD Delete message, p.176
Delete message from preferred message storage.
Example:
AT+CMGD=2 : delete second message
AT+CMGD=1,1: delete all read messages
For exact use, consult “AT Commands Interface
Guide”
AT+CSCA
Service center address,
p.162 Enter the phone number of the SMS service center
(network operator). E.g.: AT+CSCA=”0796664444”