ALESIS NanoVerb Stereo Amplifier - Manual (Page 21)

6 Editing Programs
21
To Edit a Selected Program
1. Select a program to edit using the
foot pedals or VALUE knob.
2. Turn the EFFECT knob to the
effect module or parameter you
wish to modify.
3. Turn the VALUE knob to
select an effect type or value for
the module. As soon as you
change the value, the EDITED
decimal point on the display
lights up to show you a change
has been made to the current
program.
4. If the module has a parameter
(PARAM), turn the EFFECT
knob to select the parameter.
5. Using the VALUE knob, select a
value for the parameter.
6. Continue in this way until you have completed
assignments for all modules and parameters.
To Restore Factory Presets
Once you have saved changes to a preset program, you can
still recall the original settings. To enter RESTORE
FACTORY PRESETS mode, simply hold down the VALUE
knob as you turn the unit on and then select the program to
be restored (or
for all programs). Press the VALUE
knob to confirm your selection. Any program changes you
have made will be lost, so you might want to copy the
program to another location first. See chapter 8 for
instructions on how to copy programs.
Just turn the EFFECT
knob to exit the
RESTORE FACTORY
PRESETS mode, or
turn the unit off and
then on again.
1
1
2
3
4
5
To toggle an effect
module on and off,
press both pedals while
the effect module is
selected.