Electrolux EDC2096GDW - Manual (Page 28)

Problem Possible solution
The appliance stops during opera-
tion. Make sure that the water container is emp-
ty. Press Start/Pauze (Start/Pause) to start
the programme again.
The display shows a long pro-
gramme duration.
1)
Make sure that the weight of the laundry is
applicable to the duration of the pro-
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Make sure that the room temperature is
not too warm.
The display shows a short pro-
gramme duration. Set the Tijd (Time Drying) or the Extra
Droog (Extra Dry) programme.
The display shows Err. If you want to set a new programme, de-
activate and activate the appliance.
Make sure that the options are applicable
to the programme.
The display shows E51) Deactivate and activate the appliance.
Start a new programme. If the problem oc-
curs again, contact the Service.
1) After maximum 5 hours, the programme ends automatically
10.2 If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the ap-
pliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor.
• The airflow slots are clogged.
11. TECHNICAL DATA
Dimensions (mm) Width / Height / Depth 600 / 850 – 865 / 600
Max. depth
(with the appliance door open) 1090 mm
Max. width
(with the appliance door open) 950 mm
Electrical connection Voltage 230 V
Frequency 50 Hz
Fuse 16 A
Total power 2800 W
Drum volume 118 l
28 www.electrolux.com