Water Inc HOUSEPURE HP04 - Manual (Page 3)

Important Safety Information – Read All
Instructions Before Using
• Before beginning installation, read all these instructions completely. Then obtain all
the materials and tools needed for installation.
NOTE: Failure to install the HOUSEPURE system correctly voids the warranty.
• Perform installation according to state and local plumbing codes.
• Handle all components of the system with care. Do not drop, drag or turn
components upside down.
• Be sure the floor under the water filter system is clean and level.
• The system uses 120 volt-60Hz electrical power. Always use the power cord
supplied.
- Plug power cord into an indoor 120 volt, grounded outlet.
• Install system in a protected area. Be sure electric outlet and transformer do not
come in contact with water. See Where to Install the Filter, in the installation section of
the manual.
-
Always connect the system to the main water supply pipe before the water
heater.
- Do not expose system to freezing temperatures. Water freezing in the system
causes equipment damage.
• Minimum inlet water pressure is 40 psi. Maximum inlet water pressure is 125 psi.
Use pressure reducing valve if necessary.
CAUTION: Read and follow the information in this manual to
minimize the risk of electric shock or personal injury.
IMPORTANT! If you are unsure about installing of your water filter,
contact the helpline or consult a professional plumber.
IMPORTANT! This system must be installed in compliance with
applicable state and local codes, law, and regulations.
!
®