Myron&Davis NV8THL1 - Manual (Page 5)

Step 1. Remove these two upper
bolts
Step 2. Remove these two
lower bolts.
Step 1a. Remove factory radio
and disconnect .
Step 3. Remove the factory
radio.
Step 1b. Remove the factory
radio.
Step 4. Remove the mounting
brackets
Step 5. Remove the hazard switch
by depressing the clips on the side.
Front view of the hazard switch
being removed
Step 6. Re-attach the mounting
brackets to the new radio
Remove the OEM Radio and prepare the Myron and Davis Unit for installation by
following the steps below.
Note : Inspect all fasteners and brackets for damage. Replace as necessary before the
installation process is started
5 – Remove Factory Radio