Re-install the interior trim components, 7 - connect and install the myron & davis unit – Myron&Davis NV8THL1 User Manual
Page 7
Step 2. Connect Myron and Davis
unit
Final installation view
8- Re-install the interior trim components
You will be required to re-install the interior trim components in reverse order of removal
after installing the Myron and Davis unit. Please refer to the removal steps in Section 4.
Caution:
During the installation of the interior trim components, use caution to prevent
damage to any of it’s components. Consult the Factory Service Manual for any
additional instructions.
Caution:
After installation of the trim components inspect them to insure they are secure.
Step 1. Remove transportation
screws
*Note: Be sure to connect the emergency brake for video bypass and the reverse wire if you
plan on using either back up sensors and or a back up camera .
Follow the steps below to ensure proper installation and connection of the
Myron and Davis unit.
Note:
To ensure that the video cannot be viewed while the vehicle is in motion,
connect the (blue/white) Brake Wire to the Emergency Brake Switch
(grounded when engaged)
Note:
Carefully route the wire harnesses so they cannot be damaged during the
installation process of the Myron and Davis unit
7 - Connect and Install the Myron & Davis unit