Myron&Davis NV8TCM1 - Manual (Page 5)

Remove the OEM Radio and prepare the Myron and Davis Unit for installation by
following the steps below.
Note : Inspect all fasteners and brackets for damage. Replace as necessary before the
installation process is started
5 – Remove Factory Radio
Step 1. Remove the two upper
screws securing the factory radio
Step 2. Remove the two lower
screws securing the factory radio
Step 1a. Remove factory radio
and disconnect .
Step 3. Remove the factory radio
Step 4. Remove the mounting
brackets from the factory radio
Step 5. Separate (slide) the A/C
controls from the factory radio