Myron&Davis NV8TCM1 - Manual (Page 7)

Follow the steps below to ensure proper installation and connection of the
Myron and Davis unit.
Note: To ensure that the video cannot be viewed while the vehicle is in motion,
connect the (blue/white) Brake Wire to the Emergency Brake Switch
(grounded when engaged)
Note: Carefully route the wire harnesses so they cannot be damaged during the
installation process of the Myron and Davis unit
7 - Connect and Install the Myron & Davis unit
Step 2. Screw the mounting
brakets on to the M&D unit
Step 1. Final installation view
8- Re-install the interior trim components
You will be required to re-install the interior trim components in reverse order of removal
after installing the Myron and Davis unit. Please refer to the removal steps in Section 4.
Note: During the installation of the interior trim components, use caution to prevent
damage to any of it’s components. Consult the Factory Service Manual for any
additional instructions.
Note: After installation of the trim components inspect them to insure they are secure.
Step 1.Remove transportation
screws
*Note: Be sure to connect the emergency brake for video bypass and the reverse wire if you
plan on using either back up sensors and or a back up camera .
Step 3. Connect the M&D unit
to the factory harness/