ATEN CS-1004 - Manual (Page 21)

w F2 Scan:
Pressing [F2] initiates Quick View Scanning, in which the OSD cycles
through all the ports that are currently selected in the List view (see F3,
below), and displays each one for the amount of time set with the Scan
Duration setting under the F6 Set function (see p. 19). When you want to
stop at a particular location, press the [Spacebar] to stop scanning.
Note: 1. If the scanning stops on an empty port, or one where the computer
is attached but is powered Off, the monitor screen will be blank,
and the mouse and keyboard will have no effect. To recover, key in
the Hotkey sequence (see Hotkey Port Selection, p.13), for any
Port ID that has an active computer attached.
2. As each computer is accessed and the OSD cycles through the
selected ports, an appears in front of the Port ID display to
indicate that it is being accessed under Quick View Scan Mode.
w F3 List:
This function lets you broaden or narrow the scope of which ports the OSD
lists. The submenu choices and their meanings are given in the table below:
Choice Meaning
ALL
Lists the Port ID numbers and Names (if names have been
specified - see F5), of all the ports on the installation.
QVIEW
Lists only the ports that have been selected for Quick View
scanning (see F4, below).
QVIEW or
POWERED ON
Lists only the ports that have been selected for Quick View
scanning (see F4, below), and that have their attached computers
Powered On.
QVIEW + NAME
Lists only the ports that have been selected for Quick View
scanning (see F4, below), and have been assigned names (see
F5, below).
NAME ONLY
Lists only the ports that have been assigned names (see F5,
below).
S
2001-01-13
CS-1004 / CS-1008 / CS-1016 User Manual 17