Audiovox Movies2Go 128-8652 - Manual (Page 19)

To load and Play a Disc
Press the Power button to turn the unit ON. Select DVD mode and insert the disc
(Label towards driver) into the disc compartment.
TURNING THE UNIT ON OR OFF
1. Pushing in the Screen Release button will unlock the LCD screen and it will drop
down slightly. Pivot the screen downward until a comfortable viewing angle is
reached. The hinge friction will hold the screen in position while the system is in use.
2. Pressing the power button* on the unit or the remote control will turn the system on
and off. When in use the internal backlighting will illuminate the controls.
3. After the unit has been turned on and is displaying a picture, adjust the viewing
angle, by pivoting the screen to optimize the picture quality.
4. Remember to turn the unit off and pivot the LCD to the locked position when not in
use.
Power
ON/OFF
Button
Remote Sensor
Infrared Transmitter
Screen Release
OVERHEAD DOME LIGHTS
The Dome Lights integrated into the MMD11 A are controlled by a three position
slide switch. Sliding the switch to the ON position will turn
the lights ON. The OFF position will prevent the lights from turning ON with the
vehicle’s interior lighting, and the auto position will allow the
lights to turn ON and OFF with the vehicle’s interior lighting. Refer to the Installation
Guide for wire connections. Do not leave the vehicle
unattended with the dome light switch in the ON position, as this could result in a
discharged battery.
REMOTE SENSOR
The MMD11 A infrared remote sensors to relay signals to the unit when the remote
control is pointed at the remote sensor.
19 MMD11 A