AL-KO 426 036 - Manual (Page 10)

GB6
Warranty
We will rectify any material or production faults
on the mower during the statutory period of
limitation for claims based on defects in
accordance with our choice of repair or
replacement.
The period of limitation is determined by the laws
of the country in which the mower was
purchased.
Our warranty is only valid under the following
conditions:
• The machine has been treated properly.
• The operating manual has been followed.
• Genuine spare parts have been used.
The warranty is void if:
• Attempts have been made to repair the
machine.
• The machine has been modified.
• The machine has not been used as intended.
• Commercial or municipal use, etc.
The following items are excluded from the
warranty:
• Paint damage due to normal wear.
• Natural wear and parts that are identified with
a frame XXX XXX (X) on the spare parts card.
• Combustion engines – separate warranty
conditions of the respective enginemanufacturer
apply.
In the event of a claim covered by the
warranty, please contact your dealer or the
nearest authorised customer service centre and
present this warranty declaration and the sales
receipt.
The statutory claims of the purchaser based on
defects with respect to the seller shall remain
unaffected by this guarantee undertaking.
Troubleshooting
Before carrying out any maintenance or cleaning work, pull off the spark plug connector!
Fault Remedial action
Engine does not start If the engine is cold: press the primer
Full up with petrol
Move the throttle lever to the start position
Push the spark plug connector onto the spark plug
Check the spark plug. Replace, if necessary
Clean the air filter
Engine power reduced
Resharpen / replace the blades → customer service centre
Clean the air filter
Inexact cut
Resharpen / replace the blades → customer service centre
Readjust the cutting play
Cutter drive / wheel drive
not functioning Readjust Bowden cable
V - belt defect → customer service centre
Faults that cannot be rectified with the aid of this table must be eliminated by
an authorised workshop only (customer service centre).