AL-KO 426 036 - Manual (Page 20)

GB
GB 1
Assembly
BM 5001-R (B&S)
Fill the mower with engine oil and
petrol only after it has been
completely assembled!
Pull off the spark plug connector
before starting the assembly!
i
The number printed on the left before
the text (e.g.
3
) refers to the diagrams.
. 1 . . 2 . Loosen screws and rotate handlebar
console upwards – retighten screws.
Assembly of handlebars on console
. 3 . Handlebars
. 4 . Mount handlebars on console.
Hexagonal screw M8 x 25 - (2x)
Hexagonal nut
M8 self-locking - (2x)
Bowden cable guide - (1x)
. 5 . The handlebars can be set to the user's
height by attaching them to the lower or
upper position.
. 6 . Mount the Bowden cable guide together
with the lower screw - tighten the nuts.
Assembly of blade holder
. 7 . Blade holder
. 8 . Mounting bush on the housing to
accommodate the blade holder.
. 9 . Lightly grease the mounting bush and insert
the blade holder.
10 . Fully insert the blade holder and place the
V belt around the pulley.
Place the V belt around the lower pulley
in the housing.
Assembly of recoil springs
11 . 12 . y Place the mower on its side.
y Hook in the recoil springs (2x).
Assembly of the double wheels
Carry out the following steps on both
drive wheels.
i
13 . Remove screw
hexagonal screw M8 x 45
hexagonal nut
M8 self-locking
14 . y Mount axle extender
y Re-insert screw and retighten nut.
15 . Push the wheel onto the axle extender
16 . Check the orientation of the wheel – the
tyre profiles should form a V viewed in the
direction of travel.
17 . Secure wheel with nut
Washer Ø 10 x Ø 35 x 5
Hexagonal nut M10 self-locking
18 . Press on protective cap
Assembly of Bowden cables
a) Bowden cable for throttle
y Set the throttle lever on the right-hand
handlebar to the << START>> position.
19 . Push the governor lever on the carburettor
completely to the left (= start position).
20 . y Insert the angled end of the Bowden
cable wire into the governor lever.
y Insert the Bowden cable sheath in the clip
y Gently push back the Bowden cable
sheath by hand until a resistance can be
felt.
Clamp the Bowden cable sheath in this
position.
Do not kink the Bowden cable during
assembly.