Accton Technology Wireless LAN 802.11b/g Device WN4201B - Manual (Page 86)

Wireless LAN 802.11b/g Device
86
• Verify that the MAC address has not
been filtered.
>>Wireless SoftAP™ dialog box
>>Tools menu
>>Options
>>MAC Filtering tab
>>verify that if “Enable MAC Filtering” is
enabled AND “Deny Access by MAC
Address” is selected as the Filter Method,
then the Station MAC address of the
machine you are attempting to connect
should not be listed and selected.
>>IF “Enable MAC Filtering” is enabled
AND “Allow Access by MAC Address” is
selected as the Filter Method, then the
Station MAC address of the machine you
are attempting to connect should be listed
and selected.
I have set up my wireless connection in AP
Mode, yet am unable to connect a Station
(Client machine).
• In the Wireless SoftAP™ dialog box
select the Tools menu. If the second
menu item reads “Disable Wireless”,
then contact customer support.
After activating the SoftAP™ application I
am unable to access my settings for Station
Mode / the settings input during
Windows® XP Wireless Zero
Configuration. • The SoftAP™ application is initialized
in Access Point Mode by default. From
the Wireless SoftAP™ dialog box select
the Tools menu and select Switch to
Station Mode (See Section 6.2.2.1for
instructions on switching to Station
Mode).
• Check that your network is set up to be
shared. From the Wireless SoftAP™
dialog box select the Tools menu and
select Options. Select the Devices tab.
Verify that the check box at “Share my
network connection” is selected.
If the problem still persists……….
After installing the Wireless SoftAP™ I am
able to connect from my laptop (client), yet
am unable to browse the internet.
• Verify your internet connection with
your ISP.
• Verify that your Network Keys are
entered correctly.
If the problem persists…………
My WPA security settings are not working
properly.
• Switch to WEP security on both
SoftAP™ applicataion. For AP Mode
see section 6.3.2. For Station Mode
see section 4.2.2.