LG LGD950 - Manual (Page 16)

16
2 Plug the USB cable (as shown below) into
the phone's Charger/USB Port. Make sure
the USB symbol is facing upwards.
Always unplug the charger from the wall
socket after the phone is fully charged to
save unnecessary power consumption of
the charger.
% NOTE
• The battery must be fully charged initially
to improve battery lifetime.
• Your phone has an internal antenna. Be
careful not to scratch or damage this
rear area, as that will cause loss of
performance.
• When the battery becomes fully
discharged and you connect the phone
to a charger, the Notification LED lights
will blink. This is normal operation for a
completely discharged battery to prevent
overflowing current because the phone is
designed to provide reasonable protection
against damage to the battery. Once the
battery has enough charge, the screen
will turn on and display a battery image.
• Non-Removable Battery
Your phone has an internal, rechargeable
battery that should be replaced only by
LG or an authorized LG repair center. You
should never try to open or take apart
this phone yourself. Opening the phone
can cause damage that will void your
warranty.
%
Warning
• Use only LG-approved chargers, batteries
and cables. When using unapproved
chargers or cables, it may cause slow
charging. Or, unapproved chargers or cables
can cause the battery to explode or damage
the device, which are not covered by the
warranty.
• Charging may be interrupted when you
use a USB hub, which is not retained
rated voltage.
Getting Started