LG AN215 - Manual (Page 22)

Installing and Composition
22
* Don’t unplug the power cord while the ventilation fan (inlet/outlet) is working. If so, you take longer time
by lamp on.
Turning on the Projector
Turning off the Projector
1. Connect power cord correctly.
2. Press the POWER button on the remote control or control panel.
(Green operation indicator flashes during cooling of the lamp.)
● An image will appear after the operation indicator light turns (Green).
● Select the source mode with the SOURCE button.
1. Press the POWER button on the control panel or remote control.
2. Press the POWER button on the control panel or remote control again to cut off the power.
3. If the operation indicator LED is orange and blinking, do not disconnect the mains supply until the
operation indicator LED is lit up constantly (orange).
● If the operation indicator LED is orange and blinking, the power button on the control panel or on the remote
control will not operate.
Power off?
Please press Power key again.
Selecting source mode
1. Press the SOURCE button.
2. Each press of the F , G button changes the display as below.
RGB
S-Video
HDMI
Video Component
RGB F G
Select OK