Agilent Technologies J3972A - Manual (Page 59)

Local Terminal Configuration
Using a Local Terminal
39
Serial port speed Press 5 and then enter a serial port speed (300 to 38,400
baud) for the probe’s SNMP connection. The default is
9600 baud. This speed is used only for Out-of-Band
access to the probe using SNMP. It does not affect the
serial connection for the local terminal, which is fixed at
9600 baud.
Make sure that the serial port speed is set to less than or
equal to the maximum speed of the modem to be used.
Serial port mode Press 6 and then select the serial port mode by pressing 1
for direct connection (the default) or 2 for modem
connection.
Serial port hardware Press 7 and then select hardware flow control Off by
flow control pressing 1 or hardware flow control On (the default) by
pressing 2 .
Modem Init String Press 8 to enter the modem initialization string. Only the
first 20 characters of the 256 character maximum will be
displayed in the Modify/View Serial Port Settings menu.
The default is
^s^M^d1^sATEOQOV1X4 S0=1
S2=43^M .
Modem Hangup Press 9 to enter the modem hang-up string. Only the
String first 20 characters of the 256 character maximum will be
displayed in the Modify/View Serial Port Settings menu.
The default is
^d2^s+++^d2^sATHO^M^d2 .
Modem Connect Press 10 to enter the modem connect responses. Only
Responses the first 20 characters of the 256 character maximum will
be displayed in the Modify/View Serial Port Settings
menu. The default is
/CONNECT/300/CONNECT
1200/1200/CONNECT 2400/2400/CONNECT
4800/4800/CONNECT 9600/9600/CONNECT
14400/14400/CONNECT 19200/19200/
CONNECT 38400/38400/ .