Agilent Technologies J3972A - Manual (Page 64)

Installation
Installing the Probe
44
Installing the Probe
This section describes how to install your probe. First decide which installation
method you are going to use and then install the probe using one of the following
methods:
z “Table Installation” on page 45
z “Rack or Cabinet Installation” on page 45
z “Wall Installation” on page 47
CAUTION Do not attach the power cord to the probe until the probe is completely installed.
If the power cord is already attached to the probe, remove it now (you will not
lose any configuration parameters). The probe does not have a power switch but
becomes operational when the power is attached.