Agilent Technologies J3972A - Manual (Page 94)

Bootp Server Configuration
74
Bootp Server Configuration
This chapter describes how to use the Bootp server method to configure the
Agilent J3919A or J3972A OC-3 ATMProbe so that it can communicate over the
network. This chapter assumes that you have already installed the probe, but have
not attached the power cord. If you plan to use the local terminal method of
configuration, skip this chapter and refer to Chapter 2 “Local Terminal
Configuration”.
The following sections are covered in this chapter:
z “Probe Configuration Using a Bootp Server” on page 75
z “Bootp Server Setup on an HP or Sun System” on page 77
z “Bootp Server Setup on a PC” on page 81
z “Configuring the Bootptab File” on page 87