LG BD430 - Manual (Page 44)

44
Option
Input search
This function detects the input signal
automatically. When a signal is found, the
search will stop. Use the Point ▲▼ buttons to
select one of the following options.
Off ........... Input search will not work.
On............. Active Input Sourcing function. It
detects the input signal and search
stops when the signal is found.
Auto PC Adjustment
On............. Press Auto Set button on the Top
Control or remote control to enable
Auto PC Adjustment function.
Off ........... Disables Auto PC Adjustment.
Auto keystone
Auto .........Always works and corrects
keystone distortion according to the
projector's tilt.
Manual ......Activate this function by pressing
Auto Set on the Top Control or the
Remote Control.
Off ........... Disables Auto Keystone.
Auto setup
This function enables Input search, auto keystone
and Auto PC adjustment by pressing the AUTO
button on the top control or the on the remote
control. Settings for those can be altered as
follows:
Keystone
This function is used to store or reset the keystone
correction when the AC power cord is unplugged.
Use the Point ▲▼ buttons to switch between
each option.
Store ...... .. Keep the keystone correction even
when the AC power cord is unplugged.
Reset ...... Release the keystone correction when
the AC power cord is unplugged.
To correct keystone distortion, press the OK
button.Keystone appears on the screen. Use the
Point ▲▼ buttons to correct keystone distortion.
Blue Back
You can use this item to set the background of
The time when no signal is detected.
You can press ▲▼ to switch over between the
items below:
On...... To enable the blue background for
projection;
Off...... To disable the blue background.
√ Note:
● Only the last selected input source can be
detected.
● If the INPUT button on the top control or
the RGB 1/2 buttons, HDMI,VIDEO , S-VIDEO
or COMPONENT buttons on the remote control
is pressed during Input search is in progress,
Input search will stop and go back to the
previous input signal.
● Phase, Total dots, Horizontal and Vertical
position of some computers cannot be fully
adjusted with the Auto PC Adjustment
function. When the image is not provided
properly with this operation, manual
adjustments are required.