LG LSDF995ST - Manual (Page 9)

9
ENGLISH
PA RT S A N D F E AT U R E S
• The ( ) symbol indicates that sanitary rinse has
been selected.
The symbol blinks during the cycle if the sanitary
temperature has been achieved. Once the cycle has
ended, the symbol will be steady if the sanitary
temperature has been achieved.
*NOTE: This high-temperature rinse sanitizes
dishware and glassware in accordance with
NSF/ANSI Standard 184 for residential
dishwashers. Certified dishwashers are not
intended for licensed food establishments.
• When you select Extra Rinse, an additional
rinse cycle is added.
• Rinse Only is a wash cycle described on
the previous page.
CHILD LOCK
Lamp will turn on when Child Lock
setting is on.
• To lock/unlock the buttons, press and hold the Rinse
and Spray Buttons simultaneously for 3 seconds with
the door open.
• Lock the control buttons during cycle operation to
prevent settings from being changed.
RINSE AID
Refill with rinse aid when the lamp
turns on.
DIGITAL DISPLAY
The Digital Display on the control panel
shows the estimated cycle and option
times.
When the dishwasher is powered up, the display will be
blank. When the cycle and options are selected, the
display will show the total estimated time to complete
those selections. During operation, the display shows
the remaining estimated operating time.
NOTES:
• The estimated time shown in the display does not
include delay times for heating water, etc.
• If Delay Wash is selected, the display shows the
delay time in hours.
HALF LOAD
• For small loads, you may use just the upper or
lower rack to save energy.
• Each press of the Half Load button cycles
between upper rack only and lower rack only.
• If Half Load is not pressed, the dishwasher will
run normally, with upper and lower spray arms
operating alternately.
DELAY START
• To delay the start of a selected cycle, press
the Delay Start button.
• Each time Delay Start is pressed will delay
the start of the cycle by one additional hour.
• The delay start time can be set from 1 to 19
hours in one-hour increments.
STEAM
• Press the Steam button to add steam to a
selected cycle.
• The Steam symbol will be lighted when the
STEAM option has been selected.
• The steam symbol will blink while steam is
being injected into the dishwasher.
POWER
• Pressing the Power button turns on power
to the controls.
• After the cycle is complete, the power
automatically turns off for safety and economy.
• If there is a power surge, power outage,
or disruption of any kind, the power will be
automatically turned off for safety, and the
cycle will need to be restarted.
CONTROL PANEL
(continued)
3 4
WARNING
Steam can cause burns. Use caution in the
area of the steam nozzle on the left side of
the dishwasher if the door is opened
during the steam portion of a cycle.
Contact with the steam or the steam
nozzle can cause burns.
4