LG LW5012J - Manual (Page 14)

Positioning the Air Conditioner
NOTES:
Handle the air conditioner gently.
Be sure your air conditioner does not fall out of
the opening during installation or removal.
The place where the power cord exits the air
conditioner should be no more than 6 ft (183 cm)
from a grounded outlet.
Do not block the louvers in the front panel.
Do not block the louvers on the outside of the
air conditioner.
1.Pull the left-hand curtain out until it fits into the
window channel.
2.Use a 1/8” drill bit to drill a starter hole through
the top hole in the side curtain and into the
window sash.
3.Insert one (1) of the 31/32” screws through the
top hole of the lefthand curtain and into the
window sash.
4.Repeat for the right-hand curtain.
NOTE: Your model may differ from the one shown.
5.Use a 1/8” drill bit to drill a starter hole through t
he bottom hole in the side curtain and into the
window frame.
6.Insert one(1) of the 31/32” screws through the
bottom hole of the left-hand curtain and into the
window frame.
7.Repeat for the right-hand curtain.
A. Side curtain against window channel
B. Window sash behind top channel
C. Bottom channel in behind windowsill
1.Tilt the air conditioner about 1/4” down towards
the outside for proper condensate water drainage.
Refer to the illustration below.Center the air
conditioner in the window. Make sure the bottom
guide of the air conditioner drops into the notches of
the basepan angle.Lower the window sash behind
the top channel to hold the cabinet in place.
A
B
C
A
C
D
B
A. Window frame
B. Top channel C. Bottom guide
D.Window lock bracket
ABOUT 1/4”
Attach Side Curtains to Window
Top View