LG LW8012ERJ - Manual (Page 14)

Positioning the Air Conditioner
NOTES:
Handle the air conditioner gently.
Be sure your air conditioner does not fall out of
the opening during installation or removal.
The place where the power cord exits the air
conditioner should be no more than 6 ft (183 cm)
from a grounded outlet.
Do not block the louvers in the front panel.
Do not block the louvers on the outside of the
air conditioner.
1. Tilt the air conditioner about 1/2” down towards
the outside for proper condensate water
drainage.Center the air conditioner in the
window. Lower the window sash behind the top
channel to hold the cabinet in place.
NOTE: Your model may differ from the one shown.
A
B
C
A. Side curtain against window channel
B. Window sash behind top channel
C. Bottom channel in behind windowsill
2. Loosen the screw on the right-hand side of the
air conditioner cabinet near the bottom.
3. Slide the side bracket over the screw.
4.
Tighten the screw. The side bracket should
be resting on the windowsill.
5. Use ” drill bit to drill a starter hole through
the holes in the side bracket and windowsill.
6. Using two ” screws, attach the side
bracket to the windowsill.
7. Repeat for side bracket installation on the
left-hand side of the air conditioner.