LG LP1414SHR - Manual (Page 12)

12
Press the POWER button to turn the air
conditioner ON or OFF. When you turn the air
c
tone will play and the LCD
display will show the set
temperature and any active
onditioner on, an ascending
mode.The air discharge on the top of the air
conditioner will automatically open.
When turning the air conditioner off, you will
hear a descending tone and the air discharge
on the top of the air conditioner will close.
Any control settings such as Mode, Set
Temperature, Auto Swing, etc. will be retained
in memory when the power is off.
NOTE: When turned on after being unplugged,
the air conditioner will automatically reset to
COOL mode, with a temperature setting of 72°F.
Any settings will need to be re-entered.
Control panel buttons shown. Operation
using the remote control is the same, unless
specifically noted.
NOTE: The remote sensor is located under
the air discharge and on the front panel.
Always point the remote at the sensor. The
remote may not work if the sensor is in bright
light or if there is not a clear path between the
remote and the sensor.
USING THE CONTROLS
Mode Features
COOL
(HEAT)
Compressor runs and cools the room.
Use the and FAN buttons to set
the desired temperature and circulation
fan speed.
FAN
DRY
ENERGY
SAVER
H O W T O U S E
/
Fan circulates air but compressor does
not run. Use the FAN button to set the
desired fan speed.
Dry mode is used to remove humidity
from the room without additional
cooling. Once the set temperature is
reached, the compressor and
circulation fan turns off and only the
exhaust fan will run. Fan speed is
pre-set and can not be adjusted.
Under normal operation, the exhaust
fan cycles on and off with the
compressor, and the circulation fan
runs at the set speed.
The mode helps reduce power
consumption by automatically turning
off the circulation fan as well as the
exhaust fan when the compressor is
off. The air conditioner will
automatically cycle both fans on and
off with the compressor as needed for
cooling.
POWER
Press the MODE button to select the operating
mode (COOL, FAN, DRY , ENERGY SAVER or HEAT)
for the air conditioner. And you
can see the active mode through
the LCD Display.
The default setting is COOL.
Press the MODE button to
change to FAN, press again to change to DRY,
again to change to ENERGY SAVER, again to
change to HEAT and again to return to COOL.
MODE
COOL FAN
DRY
→
→
ENERGY
SAVER
→
HEAT
→