LG CF3DAT - Manual (Page 18)

Connecting Device
18
Connecting Device
Connecting to a PC
* You can connect the projector to a computer with an VGA, SVGA, XGA or SXGA output.
* See page 51 for a list of supported monitors.
UV565F
<How to Connect>
Connect the projector's RGB IN port to the computer's
RGB output port using a computer cable.
* For IBM PC/AT-compatible laptops, video can be displayed on
both the laptop monitor and the external one. If the video is
displayed on both, the image quality on the external monitor
may not be satisfactory. In this case, configure the laptop's
video output to the external monitor only. (For more detailed
information, refer to your laptop's user manual.)
Computer Cable
Computer Cable
Connecting an Antenna
Connecting a Speaker or Headphones
To watch TV programs using an indoor/outdoor antenna, connect the
antenna line to the projector's ANTENNA IN port.
* Be careful not to bend the copper wire when connecting the (75Ω) coaxi-
al cable.
* Turn the input jack to the right to fasten it.
* Ensure you use a standard coaxial cable (75Ω) when connecting to the
TV input.
* To obtain better image quality in locations where signal strength is low,
please purchase and install a signal amplifier (booster).
* A signal splitter is required if one antenna sends a signal to more than
two TVs.
* If you have any problems with antenna installation, please consult a spe-
cialist retailer or the retailer from which you purchased the antenna.
To listen to sound through speakers, earphones or headphones,
connect them to the voice output jack of the projector.
Cable signal
connector
Indoor/outdoor
antenna
(VHF, UHF)
Be careful not to
bend the copper
wire.
Coaxial cable
Coaxial cable
(75 Ω)