LG CF3DAT - Manual (Page 36)

Function
36
Network Settings
< Notes >
• Use a standard LAN cable with this projector. (Cat5, Cat5E, or Cat6 with an RJ45 connector)
• If you experience any connection problems, restart your modem.
• A 10 Base-T or 100 Base-TX LAN port is required to connect to this projector. If your ISP (Internet Service Provider)
does not provide such a connection, you will not be able to connect the projector to the network.
• To connect to a wireless router, a router that supports wireless connection is necessary; the wireless connection function
of the corresponding router must also be activated. Ask the router manufacturer whether the router supports wireless
connection.
• To connect to a wireless router, verify the SSID and security settings of the wireless router. Please refer to the user
guide of the corresponding router regarding SSID and security settings of the wireless router.
• The projector may not work properly if network devices (wire/wireless router or hub, etc.) are incorrectly set up. Be sure
to install the devices correctly by referring to their user guides before configuring network settings.
• When Ad-hoc is used, the projector may not be able to connect depending on the device (for example: notebook
computer) that is connected.
• The connection method may vary according to the manufacturer of the wireless router.
1. Press the MENU button, then go to OPTION with the ∧, ∨, ＜,
＞ buttons and press OK .
2. Press the ∧, ∨ buttons to go to High Altitude and press OK .
3. Press the ＜, ＞ buttons to select On and press OK .
ꔈPress the BACK button to exit the menu screen.
High Altitude
OPTION
Menu Language : English
Audio Language : English
Caption : Text 1
Blank Image : Black
Camera Calibration
Lamp Mode : Normal
High Altitude : Off ꔉ
Network Setting
Set ID : 1
ꔂ Move ꔉ OK
* High Altitude is used at environments higher than 4,000 feet.
1. Press the MENU button, then go to OPTION with the ∧, ∨, ＜, ＞
buttons and press OK .
2. Press the ∧, ∨ buttons to go to Lamp Mode.
3. Press the ∧, ∨ buttons to select an option.
(Normal, Economic)
ꔈ If room temperature is over 35°C or the 3D video is working, this is not
available.
ꔈ You can select this function through the MENU button.
ꔈ Press the BACK button to exit the menu screen.
To adjust the brightness of the screen
OPTION
Menu Language : English
Audio Language : English
Caption : Text 1
Blank Image : Black
Camera Calibration
Lamp Mode : Normal ꔉ
High Altitude : Off
Network Setting
Set ID : 1
ꔂ Move ꔉ OK