LG WM2350HRC - Manual (Page 23)

ENGLISH
H O W TO U S E
At the beginning of the cycle,
the washer tumbles the load
and detects the weight of the
clothes. The display will indicate the approximate
load size in the LOAD SIZE display. This allows
you to adjust the amount of detergent and other
additives for best results and improved efficiency.
CUSTOM PROGRAM
LOAD SIZE SENSING SYSTEM
CUSTOM PROGRAM allows you
to store a customized wash cycle
for future use. It allows you to save
favorite temperature, spin speed, soil
level, and other options for a cycle,
and then recall them at the touch of a button.
To store a Custom Program:
Select a cycle.
Adjust the Wash/Temp., Spin Speed, and Soil
Level to the desired settings.
Set any other desired options.
Press and hold the CUSTOM PROGRAM
button for 3 seconds. You will hear two
beeps to confirm the settings have been
stored.
To recall a Custom Program:
Press and release the CUSTOM PROGRAM
button. The stored settings will be displayed.
Press and release the START/PAUSE button
to start the cycle. The washer will start
automatically.
To use Automatic Load Size Sensing:
Load the washer, select the desired cycle and
options, and then start the cycle by pressing
the START/PAUSE button.
The washer will tumble for a short time to
detect the size of the load. After the washer
detects the load size, the washer will show the
detected size in the LOAD SIZE display for 10
seconds before it continues with the cycle.
During the 10 second delay in step three, press
the START/PAUSE button to pause the cycle.
Fill the detergent and additive compartments
of the detergent drawer with detergent/dditive
amounts based on the load size the machine
has detected. Following these guidelines can
save detergent.
Press the START/PAUSE button again to
resume the cycle.
To check the load size during the wash portion of
the cycle, press and hold the RINSE+SPIN button
for 3 seconds. The LOAD SIZE display will be
activated for 10 seconds.
NOTE: The load detection routine only works with
dry clothes. Since the detection system is detecting
the WEIGHT of the load, it will be affected by
unusually heavy articles in the load. For example,
a garment that is already wet that is loaded with
other items will cause the LOAD SIZE reading to be
inaccurate.
If you do not desire to take advantage of the load
size detection feature, simply load the desired
amount of detergent and additives in the dispenser
and start the washer in the usual manner.
1
1
1
2
2
2
3
4
5
3
4
IMPORTANT: If you press and hold the
CUSTOM PROGRAM button for 3 seconds, you
will overwrite any previously stored CUSTOM
PROGRAM.
23
The LOAD SIZE display:
Example 1 : If the washer has detected a small load
size, the display may only show one lighted bar. Only
a small amount of detergent should be used, because
the amount of clothing and the quantity of water that
will be used is small.
NOTE: Because the washer uses a very small
amount of water, care should be taken when
deciding how much detergent to use. Normal loads
only need about half the detergent manufacturer’s
recommended amount. This saves detergent by
using it in a more concentrated manner. However,
for heavily soiled loads, additional detergent should
be added. Never exceed manufacturer
Example 2 : If the washer has detected a large load
size, the display may show all four bars lighted.
More detergent should be used, because the
amount of clothing and the quantity of water that
will be used is greater.
Recommended
amount for
this load
Detergent
manufacturer’s
recommended
amount for a full
load
Detergent
manufacturer’s
recommended
amount for a full
load
Recommended
amount for
this load
MFL62526898_en_110726.indd 23 2011.7.26 10:32:27 AM