Auto Page RS-610 - Manual (Page 3)

D. LED DISPLAY:
E. CHIRP INDICATOR:
F. PARKING LIGHTS:
TWO STEPS DOOR UNLOCK: This feature will independently unlock
the driver door only when deactivating the system. Pushing the
button a second time within 3 seconds will unlock the entire vehicle.
G. DEACTIVATING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost
or inoperative.
1. Enter the vehicle and turn the ignition switch to ‘ON’ position.
2. Within 10 seconds push and release the valet switch
If starter disable is installed. You can now start and operate the vehicle
normally.
H. VALET MODE:
The valet switch allows you to temporarily bypass all system function,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, and remote start
functions are bypassed, however the remote panic feature and remote
door locks will remain operational. To use the valet mode, the system
must first be deactivated either by using you remote transmitter, or by
operating the Manual override sequence.
Enter Valet Mode:
1. From the Unlock condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The
LED will remain on as long as the system is in ‘valet mode’.
LED Function
Off Disarmed
Slow flash Armed
On (solid) Valet Mode
Chirp Function
1 Chirp Arm
2 Chirps Disarm
6 Chirps Car Locator
Parking light Function
1 Flash Arm
2 Flashes Disarm
12 Flashes Car Locator
Constant On Under Remote
Start