Auto Page RS-610 - Manual (Page 6)

C. TO OVERRIDE VEHICLE FROM REMOTE START CONTROL:
To operate the vehicle while running on the remote start.
1.
Insert the ignition key and turn it to “ON” ( not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON posi-
tion, the engine will shut down.
D. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been
removed from the ignition. This feature is useful for occasions when you
wish to exit and lock the vehicle for short periods of time, but would like to
leave the engine running and the climate control on.
1. Before turning off the engine, press the button on the transmitter..
The parking lights will come on and the LED will flash 3 times to
confirm Temporary Stop feature ‘ON’
2.
Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shut-
down input is received.
E. TIMER START:
This unit can be programmed to start and run the engine every 3 hours.
The engine will run for the programmed run time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, Never start
and run the vehicle in on enclosed space as a garage or carport.
3 hours timer start: This feature is design for an extreme cold climate
usage. The system will auto start the vehicle every 3 hours, to prevent
engine freezing and hard to start.
A MAXIMUM OF SIX CYCLES CAN OCCUR.
ENTER:
1. Press the button to remote start the vehicle. As soon as the vehicle
is running and the parking lights have turned ‘ON’.
2. Imediatley depress the button then press and hold down button
3 seconds. The parking light will flash (3) times. The horn chirps (3) times.
The vehicle is now programmed to start every (3) hours.
3. Press the brake pedal to stop the vehicle running.
Exit the timer start:
Timer start can be exited manually as follows:
1. Repeat the Enter Steps from above.
Or
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The LED and parking light will flash (4) times. The
horn chirps (4) times.