Audiovox 4GHz - Manual (Page 8)

E - 7
INSTALLATION
Handset Installation and Charging
Plug the AC/DC adaptor jack into the back of
the charger and then plug the AC/DC adaptor
into a compatible wall socket. The rechargeable
battery pack must be charged for approximately
10 hours before first use. The battery pack will
not have been inserted into the handset so
please insert the battery pack into the back of
the handset. Place the handset into the cradle
and the CHARGE LED should light, indicating
the battery pack is being charged. After 10
hours, your telephone will be ready to use.
Placing the Battery Pack
• Remove the battery door to slide downward.
• Connect the new battery pack into the
battery compartment.
• Replace the battery door to slide upward.
NOTE : When the handset is first time power
up, the display will show “REGISTER”, press
YES (3) to start registration and then :
• Press and hold the PAGE button on the new station, (about 6 seconds), until the LED flashes
and release the PAGE button after stops (flashing). This will put the base into subscription
mode for about 5 minutes.
• Enter the PIN code “4321” then press YES (3) to confirm
• Press scroll keys
5/6(6) to select a new base ID number for new base station.
• Press YES (3) to confirm the base number, then handset will start the subscription and
“SEARCHING. . . “ is displayed.
• “REGISTERED x” will be displayed for a few seconds and then “H x” be shown on LCD if
the subscription is successful. Else, “H ?” will be shown for fail subscription.
For detail procedure, please refer page E-10 for registration again.
9038_1_ib_e.p65 10/31/03, 12:13 PM 7