AT&T System 85 User Manual
Page 41
CHAPTER 4. OPERATING PROCEDURES
7 .
If you use direct trunk group selection to
direct trunk group selection, go to Step 9.
8.
Press direct trunk group select button.
Listen for dial tone, busy tone, or audio:
select trunks, do Step 8. If you do not use
Dial tone—trunk is connected. ANS light goes on. Go to Step 10.
Busy tone—no trunk available, and queuing is not available. Go to Step 13.
Audio (music or recorded announcement)—call is placed in queue because no
outgoing trunks are available. Go to Step 12; do a, b, or c.
9.
Press
[START]
, and dial Trunk Group access code.
Listen for dial tone, busy tone, or audio:
Dial tone—trunk is connected. ANS light goes on. Go to Step 10.
Busy tone—no trunk available, and queuing is not available. Go to Step 13.
Audio (music or recorded announcement)—call is placed in queue because no
outgoing trunks are available. Go to Step 12; do a, b, or c.
10.
Dial the outside number.
Listen for ringback tone until called party answers. ANS light goes on at this point if
you used AAR/ARS to connect a trunk.
11.
At the end of the conversation, press
[RELEASE]
.
ANS and ATND lights go off. PA light goes on.
12. Do a, b, or c.
a.
b.
c.
Stay on the line, and wait for a trunk.
press
[CANCL]
to cancel the queued call. Press
[START]
, and place the call
again.
Press
[RELEASE]
.
ATND and ANS ligths go off. PA light goes on.
Press
[HOLD]
to put the queued call on hold.
Press
[RELEASE]
.
ATND and ANS lights go off. PA light goes on.
d.
13.
4-19