AT&T System 85 - Manual (Page 92)

CHAPTER 4. OPERATING FEATURES
1. Press an idle loop button.
ATND light goes on. PA light goes off.
2. Press [START] .
Listen for dial tone.
3 . Dial the Common Service Terminal Override access code.
Listen for confirmation tone. Calls are now routed to the night security desk.
4.
Press [RELEASE] .
ATND light goes off. PA light goes on if no calls are waiting.
To activate Unattended Console Service after terminal assignments have been set up or after
common or default service telephone/voice terminals have been assigned:
1. Press [UNA] .
UNA light flashes. Calls are routed to common or default service telephone/voice
terminals.
To cancel Unattended Console Service:
1. Press [UNA] .
UNA light goes off. If no calls are waiting, PA light goes on. Calls are no longer
routed to common or default service telephone/voice terminals.
Unattended Console Service in a Tenant Services Environment
Tenant services allows unattended console service to be divided by attendant partitions.
These partitions, and not the individual consoles themselves, are marked as being in
unattended console mode. When a call comes into a particular attendant partition, that is in
unattended console mode, that call is routed to the night extension for that partition.
If trunk-to-voice terminal assignments are set up, the incoming call is routed to the assigned
telephone/voice terminal without regard to the trunk’s attendant partition (trunk-to-terminal
assignments are not affected by partitioning).
If no direct trunk-to-terminal assignment is set up, the call routes to the common night
terminal for the incoming call’s particular attendant partition (set up by the attendant).
4-70