Abit AW9D-MAX - Manual (Page 58)

[IDE-2]: “IDE1” connector served as [Secondary Master] and [Secondary Slave] channel.
“SATA1” and “SATA3” connector served as [Primary Master] and [Primary Slave] channel. The
remaining “SATA2” and “SATA4” connectors are disabled.
Refer to the following table for the relationships between IDE and SATA ports.
PATA IDE
Mode
IDE
Channel
1 Master
IDE
Channel
1 Slave
IDE
Channel
2 Master
IDE
Channel
2 Slave
IDE
Channel
3 Master
IDE
Channel
3 Slave
IDE
Channel
4 Master
IDE
Channel
4 Slave
IDE-1
IDE
Master
IDE Slave SATA2 SATA4 None None None None
IDE-2 SATA1 SATA3
IDE
Master
IDE Slave None None None None
※ This option is configurable only when the item [On-Chip SATA] is set to
[Combined Mode].
On-Chip PCI Device
Click <Enter> key to enter its submenu:
Phoenix – AwardBIOS CMOS Setup Utility
On-Chip PCI Device
On-Chip USB Controller Enabled Item Help
- USB 2.0 Controller Enabled
- USB Keyboard Support Via OS
- USB Mouse Support Via OS
On-Chip Audio Controller Auto
↓↑→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
On-Chip USB Controller
This option enables or disables the USB controller.
- USB 2.0 Controller
This option enables or disables the USB 2.0 controller.
- USB Keyboard Support via
Select [BIOS] for the legacy operating system (such as DOS) that does not support USB
keyboard.
3-22 AW9D-MAX, AW9D