Alpine Bluetooth CD Receiver CDE-136BT - Manual (Page 11)

11
-EN
Listening to Radio
1
Press SOURCE  to select TUNER mode.
2
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  AM  F1 (FM1)
3
Press TUNE A.ME to select the tuning mode.
DX SEEK (Distance mode)  SEEK (Local mode)  OFF (Manual
mode)  DX SEEK
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is advanced a single station at a time (regardless of
the signal strength at each frequency).
4
Press  or  to tune in the desired station.
Holding down  or  will change the frequency
continuously.
Presetting Stations Manually
While receiving the station that you want to store, press
and hold, for at least 2 seconds, any one of the preset
buttons (1 through 6) into which you wish to store the
station.
The display shows the band, preset number and station
frequency memorized.
Notes
• A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
Presetting Stations Automatically
1
Press BAND repeatedly until the desired radio band is
displayed.
2
Press and hold TUNE A.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
Select the band, and then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Frequency Search Function
You can search for a radio station by its frequency.
1
Press and hold ENTER for at least 2 seconds in Radio
mode to activate Frequency search mode.
2
Turn the Rotary encoder to select the desired frequency.
3
Press ENTER to receive the selected frequency.
Note
• Press  in the search mode to cancel. Or, the search mode will be
canceled if no operation is performed for 10 seconds.
Radio
 
SOURCE/ 
TUNE/A.ME
BAND
Rotary encoder/ /ENTER 
Preset buttons
(1 through 6)