ASA Electronics LCM1511WTV - Manual (Page 13)

5. Tuner Functions: (Performed only by IR Remote)
5-1 Power
Press and hold the POWER On/Off button on the IR remote
controller
unit the system turns ON. Repeat this procedure to turn the
power off.
Power-On: The LCD monitor will light up, and the green LED on
the
front panel of the monitor will be On. The On Screen Display
(OSD)
will show the last position where you turned the unit Off. (For
example, when you are on CATV Ch. 38, then turn the power
OFF,
the next time you power up the screen will display CATV Ch.
38).
Turning OFF power: The monitor screen will be dark and the
indicator
will turn orange. The system will go into stand-by mode.
5-2 TV/CATV/AV1/AV2 Mode Selection
Use the TV/CATV button to switch between TV/CATV/AV1/AV2.
System Air CATV
US-181 (NTSC) Cable TV Channels 2~69 Cable TV Channels 2 ~ 125
PAL/DK Cable TV Channels 1~57 Cable TV Channels 1 ~ 63
PAL/BG Cable TV Channels 2 ~69 Cable TV Channels 1 ~ 57
PAL/AI Cable TV Channels 21 ~ 69 Cable TV Channels 1 ~ 53
JAPAN Cable TV Channels 1 ~ 62 Cable TV Channels 1 ~ 63
Mode source Description
AV1 External Audio and Video Input 1
AV2 External Audio and Video Input 2
NOTE: First press of the TV/AV button, system will display status
only.
Press it again to perform switching function.
5-3 TV/CATV Channel Programming
Use AUTO PROG. button to memorize the channels in CATV or
VHF/UHF. When you press the AUTO PROG. Button, the tuner
will start
to scan all of the available channels and put the active ones
into