American DJ Sonic Beam II - Manual (Page 2)

Sonic Beam II™ Introduction
FEATURES:
Sonic Beam II™ features include:
• Single Gobo/Color wheel, with smooth color crossfading
stepper motor.
• 14 colored Gobos plus spot, with bi colored gobos and
multicolored gobos.
• High Speed Shutter with variable Speed and Bi-color
strobe
• 180 degree pan 360 degree barrel rotation.
• Full Micro-stepping, with 3 stepper motors.
• Built in Microphone
• Auto switch to Stand-Alone (Master/Slave) operation
when DMX signal is disconnected
• Run up to 16 heads without controller.
• DMX-512 protocol & MIDI capable
• Full Focusing.
• Fan cooled
• Uses 4 DMX Channels.
Improvements and changes in specifications and design to
this manual and unit may be made at any time without
prior notice.
Sonic Beam II™ Introduction
WARNINGS:
• Do not spill water or other liquids in to or on to your unit.
• Be sure that the local power outlet match that of the
required voltage for your unit.
• Do not attempt to operate this unit if the power cord
has been frayed or broken. Please route your power
cord out of the way of foot traffic.
• Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to
reduce the risk of electrical shock and fire in case of an
internal short.
• Disconnect from main power before making any type
of connection.
• Do not remove the top cover under any conditions.
There are no user serviceable parts inside.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will
allow proper ventilation. Allow about 6” (15cm)
between this device and a wall.
• Do not attempt to operate this unit, if it becomes
damaged in any way.
• Never operate this unit when it’s cover is removed.
• To reduce the risk of electrical shock or fire, do not
expose this unit rain or moisture
• This unit is intended for indoor use only, use of this
product outdoors voids all warranties.
• During long periods of non-use, disconnect the unit’s
main power.
• Always mount this unit in safe and stable matter.
© American DJ Supply ® - www.americandj.com - Sonic Beam II™ Instruction Manual Page 4
Quick Start Stand Alone Mode
Connect all your units together via the XLR connector. You
can connect up to 16 units together in Master/Slave mode.
The master unit will run the slaves to the masters built in
programs and internal microphone. Plug in all units. When
the Sonic Beam II™ is first turned on, it will run through an
internal self test where it moves all motors to their zero
position. After the self test the units will react to sound, and
chase to the several built in programs.
© American DJ Supply ® - www.americandj.com - Sonic Beam II™ Instruction Manual Page 3