Alvarion BREEZENET BU-DS.11 - Manual (Page 29)

Installation
2-13
Installing the Indoor Unit
Route the indoor-to-outdoor cable into the building so that it conveniently reaches
the indoor unit while avoiding interference sources. It is recommended that the
cable be a little longer then necessary. The cable is supplied open ended so it can
be conveniently threaded as shown into the building.
1.
The unit can be placed on a desktop or a shelf. Alternatively, it may be wall-
mounted. The drilling template included with the unit can be used to simplify
the wall installation process.
2.
Assemble an RJ-45 connector with a protective cover on the indoor side of the
indoor-to-outdoor cable. Refer to Appendix B for instructions on preparing the
RJ-45 cable connector.
3.
Connect the indoor-to-outdoor cable to the Radio connector, located on the top
panel of the indoor unit shown in Figure 2-6. The indoor-to-outdoor cable
should be connected to the unit before the unit is connected to the mains
power.
4.
After connecting the outdoor unit to the indoor unit using the indoor-to-
outdoor cable, connect the power cord to the unit’s AC socket, located on the
bottom panel. Connect the other end of the power cord to the AC mains after
verifying that the unit is rated for the voltage in the country of use; the AC
rating is indicated on the bottom panel of the indoor unit.
NOTE:
The color codes of the power cable are:
Brown: phase ~
Blue: neutral 0
Yellow/Green: grounding
5.
Verify that the yellow POWER LED located on the top panel is lit, indicating
that the unit is supplying power to the radio port.
Figure 2-6: Indoor Unit Top Panel