Acura 2010 RDX - Manual (Page 192)

Loading CDs in the Changer
To load multiple discs in one
operation:
1. Press and hold the LOAD button
on the changer unit until you hear
a beep. You will see
‘‘BUSY’’ on
the center display, and disc load
indicator turns red and starts
blinking.
2. Insert the disc into the disc slot
when the disc load indicator turns
green and
‘‘LOAD’’ appears on the
center display at the same time.
Insert it only halfway; the drive will
pull it in the rest of the way. You
will see
‘‘BUSY’’ on the center
display, and the disc load indicator
turns red again and blinks as the
CD is loaded.
3. When the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display again, insert the
next CD in the slot.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
4. Repeat steps 1 through 3 until all
six positions are loaded. If you are
not loading all six positions, press
the LOAD button again after the
last CD has loaded.
‘‘DISC READ’’
appears on the center display, then
the system begins playing the last
CD loaded.
If you stop loading discs before all
six positions are filled, the system
will wait for 10 seconds, stop the load
operation, and begin playing the last
disc loaded.
To load a single disc:
1. Press and release the LOAD
button on the changer unit. You
will see
‘‘BUSY’’ on the center
display, and the disc load indicator
turns red and starts blinking.
2. Insert a disc into the disc slot
when the disc load indicator turns
green and
‘‘LOAD’’ appears on the
center display at the same time.
Insert the disc only about halfway;
the drive will pull it in the rest of
the way. You will see the disc
indicator blinking on the center
display.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
Playing Discs (Models without navigation system)
188
09/07/07 15:02:04 10 ACURA RDX MMC North America Owner's M 50 31STK630 enu
2010 RDX