Advantech TPC-1260 - Manual (Page 17)

Chapter 1 General Information 7
1.7 Mounting
1.7.1 Panel mounting
1. There is a piece of adhesive waterproof gasket on the Mg-Al front
bezel. Make sure the waterproof gasket is in position before install the
TPC-1260 to the panel opening.
2. Install the TPC-1260 to the panel opening.
3. Find out the eight clampers and eight long screws in the accessory
pack. Hook those clampers to those holes around the four sides of the
bezel. Insert the screws to every clamper and fasten them. These
screws will then push on the mounting panel and fix the unit.
4. The mounting panel thickness is suggested to be less than 6mm
(0.236 inch).
Figure 1.7-1 Panel mounting
Figure 1.6-1 I/O ports arrangement
<6mm