Alpine iDA-X100M - Manual (Page 43)

42
-EN
USB cable connection
Insert a USB cable into the unit, and fix with a lock screw.
iPod Connection (sold separately)
USB connection
Connect USB cable to an iPod with iPod Dock interface cable.
Full Speed™ connection
Connect Full Speed™ connector to an iPod with FULL SPEED
TM
connection cable (KCE-422i).
Remove the iPod
Remove the iPod from FULL SPEED™ Connection Cable or iPod
Dock interface cable.
• If USB is connected, after the unit has been changed to a source
other than the iPod, remove the iPod. If the iPod is removed in the
iPod mode, data may cause damage.
• If sound is not output or the iPod is not recognized even when the
iPod is connected, remove the iPod once, then connect it again, or
reset the iPod.
• Before connecting the iPod to this unit, set the EQ function of iPod to
OFF.
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
Remove USB memory
Pull out USB memory squarely from the USB cable.
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
Portable Audio Player Connection (sold separately)
Connect Portable audio player
Connect the cable supplied with a Portable audio player to
the USB cable.
Remove Portable audio player
Disconnect the Portable audio player from the supplied
player cable.
• Refer also to the Owner’s Manual of the Portable audio player.
USB Cable
iPod Dock interface Cable
USB cable
FULL SPEED™
Connection Cable
(KCE-422i) (Sold separately)
USB memory
USB cable
USB memory
USB cable
USB cable
Supplied cable for the Portable audio player