Alpine iDA-X100M - Manual (Page 45)

44
-EN
Antenna Receptacle
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the boat’s power
antenna. Do not use this lead to turn on an amplifier, or a signal
processor, etc.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
Audio Interrupt In Lead (Pink/Black)
Illumination Lead (Orange)
This lead may be connected to the boat’s lighting system.
This will allow the backlighting of the iDA-X100M to dim
whenever the boat's lights are turned on.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the boat’s fuse box
or another unused power source which provides (+) 12V
only when the ignition is turned on or in the accessory
position.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the boat’s
battery.
Ground Lead (Black)
Connect this lead to a wire connected directly to the boat’s
negative battery terminal.
Power Supply Connector
Right Front (+) Speaker Output Lead (Gray)
Right Front (-) Speaker Output Lead (Gray/Black)
Right Rear (-) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (-) Speaker Output Lead (Green/Black)
Left Front (-) Speaker Output Lead (White/Black)
Left Front (+) Speaker Output Lead (White)
Fuse Holder (10A)
Ai-NET Connector
Connect this to the output or input connector of another
device (CD Changer, Equalizer, HD Radio TUNER
MODULE, etc.) equipped with Ai-NET.
• Be sure to set “Setting the Connected Head Unit (MODEL SETUP)”
to “CD CHG”, when the DHA-S690 is connected.
• Interface adapter for iPod (KCA-420i) is not recommended for use
with this product.
Steering Remote Control Interface Connector
To steering remote control interface box.
For details about connections, consult your nearest Alpine
dealer.
Rear Output/Input RCA Connectors
It can be used as Rear Output or Input RCA Connectors.
RED is right and WHITE is left.
Front Output/Input RCA Connectors
It can be used as Front Output or Input RCA Connectors.
RED is right and WHITE is left.
Subwoofer RCA Connectors
RED is right and WHITE is left.
Ai-NET Cable (Included with CD Changer)
RCA Extension Cable (sold separately)
Full Speed™ Connector
Control iPod signals.
Connect this to an iPod or to an optional Bluetooth Box. To
use a hands-free mobile phone, an optional Bluetooth Box
connection is required. For details on connection, refer to
the Owner’s Manual of the Bluetooth Box.
You can also connect this to an external device (such as a
portable audio player) by using iPod Direct/RCA Interface
cable (KCE-236B, sold separately).
FULL SPEED™ Connection Cable (KCE-422i) (sold
separately)
System Switch
When connecting a processor or divider using Ai-NET,
place this switch in the EXT AP position. When no device is
connected, leave the switch in the NORM position.
• When the IMPRINT audio processor is connected, set to EXT AP
position.
• Be sure to turn the power off to the unit before changing the switch
position.
USB Connector
Connect USB cable.
USB cable
Connect this to a USB memory / Portable audio player or to
an iPod. To use an iPod, iPod Dock interface cable
connection is required.
• Use the supplied USB cable. If a USB cable other than the supplied is
used, correct performance cannot be guaranteed.
• Route the USB cable away from other cables.
Marine Remote Commander Connector
This connector is used to connect the Marine Remote
Commander (sold separately).
For details about connections, consult your nearest Alpine
dealer.