HP ProLiant DL145 G3 Server - Manual (Page 28)

Using LO100 28
Controlling server power remotely
LO100 enables you to remotely operate the power button of a host server using a web browser or the
CLP. LO100 virtual power support enables you to power on, power off, and power cycle the host server.
This virtual power support operates independently of the state of the operating system.
Controlling server power from a browser
The Virtual Power screen displays current power status, how long the server has been powered on, and
the reason for the last server restart. To display the Virtual Power screen, on the main menu navigation
bar, click Virtual Power.
To modify Chassis Actions, select a Power Control Option in the Chassis Actions section, and then click
Apply.
To identify the server in the rack and illuminate the UID (the LED on the front panel of the server), from the
UID list, select the length of time for the UID to illuminate, and then click Identify.
NOTE: The UID is not available on all LO100 servers. For more information, see your server
user guide.
A restore policy controls how the system responds when power is connected to the server. To set a restore
policy:
1. Select the Power Restore Policy by choosing one of the following options:
o Always power up—Powers on the server immediately after power is supplied.
o Restore to powered state prior to power loss—Powers on the system if the system was in the
powered on state before a loss of power.
o Power pushbutton or command required to power on system—Causes the server to wait for
external action before powering on the system.
2. Click Set.