HP ProLiant DL145 G3 Server User Manual
Page 55
Using LO100 55
b.
Clear Return key sends Telnet New Line instead of ^M.
LO100 has a default of 0x08 (input) and 0x03 (output) filter setting that must not be changed. If the
default settings are changed, functionality issues might occur and you must restore the default settings.
After the defaults are reset, you must log out and back in to the shell to restore normal functionality. To
restore the default settings, use the following IPMI commands for your environment and operating system:
•
To set telnet inbound to 0x08:
o
CLP: oemhp I 20 c0 20 18 00 29 01 00 00 02 00 08 b4
o
DOS: ipmitool 20 c0 29 01 00 00 02 00 08
o
Linux: ipmitool raw 0x30 0x29 0x01 0x00 0x00 0x02 0x00 0x08
•
To set telnet outbound to 0x03:
o
CLP: oemhp I 20 c0 20 18 00 29 01 00 00 02 01 03 b8
o
DOS: ipmitool 20 c0 29 01 00 00 02 01 03
o
Linux: ipmitool raw 0x30 0x29 0x01 0x00 0x00 0x02 0x01 0x03
•
To set SSH inbound to 0x08:
o
CLP: oemhp I 20 c0 20 18 00 29 01 00 01 02 00 08 b3
o
DOS: ipmitool 20 c0 29 01 00 01 02 00 08
o
Linux: ipmitool raw 0x30 0x29 0x01 0x00 0x01 0x02 0x00 0x08
•
To set SSH outbound to 0x03:
o
CLP: oemhp I 20 c0 20 18 00 29 01 00 01 02 01 03 b7
o
DOS: ipmitool 20 c0 29 01 00 01 02 01 03
o
Linux: ipmitool raw 0x30 0x29 0x01 0x00 0x01 0x02 0x01 0x03
For example, to restore the default setting using telnet in Windows®:
1.
Log in to the CLP interface from a Windows® Telnet client.
2.
Change the directory to map1 using the command:
cd map1