HP Integrity rx4640 Server - Manual (Page 44)

Deploying Integrity Support Packs in Microsoft Windows
To deploy an ISP stored in a centralized, network-based software repository from a
command line prompt on multiple-target servers:
1. Follow steps 1 through 5 in the section “Scenario 2: Deploying Software on a Single-
Target System with the Remote Deployment Console Utility.”
2. Launch the Remote Deployment Console Utility, using command line parameters to
specify each of the target systems. For more information, refer to “Command Line
Examples” in the “Remote Deployment Console Utility for Microsoft Windows” section
in this chapter.
IMPORTANT: The target systems must be accessible over the network connection, and the
account that is running the Remote Deployment Console Utility must have administrative access
to the target system.
NOTE: Command line help for the utility is accessible by running the file SETUPC.EXE from the
command line. A screen displays all possible parameters that the utility will accept.
3. Complete the deployment. Refer to step 7 in the section, “Scenario 2: Deploying
Software on a Single-Target System with the Remote Deployment Console Utility,” for
the remainder of the deployment process and any error messages that might appear.
TIP: Although each component that is run will write installation information to the installation log
file CPQSETUP.LOG on the target system, you can redirect screen output to text files that are local
to the administrative system. This capability provides convenient local access to multiple-target
server deployment information from one location. Refer to the operating system documentation for
more information about output redirection.
2-34 HP Integrity Support Pack and Deployment Utilities User Guide