AMC WiFi Wireless Transmitter TR1a - Manual (Page 13)

AV2 (Mini AV)
DVD-2
AV1
(DVD-1)
S VIDEO
1. Connect the Cable TV or Broadcast TV Antenna to the "TV Tuner" connector on
rear side panel of TR1a
2. Connect source devices to "S VIDEO", "AV1" and "AV2" input connectors on rear
side panel of TR1a
Use S-Video cable included in TR1a to connect your source device with S-Video
output to the S Video input connector of TR1a.
Use 3 RCA plug to 3 RCA plug Composite AV cable (Yellow for Video, White for
Audio-L, Red for Audio-R) included in TR1a to connect your source device like DVD
Player with Composite outputs to the AV1 inputs of TR1a.
Use 3 RCA plug to 3.5mm mini jack Composite AV Cable included in TR1a to
connect your source device like your 2nd DVD player with Composite outputs to the
AV2 input (3.5mm mini AV jack) of TR1a.
3. Connect to DC12V Power supply and LAN through Ethernet RJ-45. Connect
12VDC/ 1.0A Power Adaptor to DC12V input connector. The RJ-45 on TR1a is for
firmware updating. This function is an option for each special designed LAN as
each proprietary system.
4. You now can switch the OFF/ON slide switch to ON position and start to enjoy the
programs from the TR1a you just setup through receivers like AMC i-M15a,
computers or other corresponding receivers.
5. The power LED (LED2) should be lighted once the OFF/ON slide switch switched to
ON position
11