AMC WiFi Wireless Transmitter TR1a - Manual (Page 8)

6
FRONT SIDE PANEL
FRONT PANEL
1. Connector for IR Blaster
2. Connector for Stereo Audio Pre-Out
(Option)
The 3.5mm mini connector is for IR
B l a s t e r O u t p u t . I R B l a s t e r s c a n b e
hooked up to the connector.
The 3.5mm mini connector is for Stereo
A u d i o P r e - O u t . T h e P r e - O u t i s f o r
connecting to external Stereo Audio
systems and the latency between the
P r e - O u t a n d V i d e o w i l l h a v e t o b e
adjusted by time delay module. So, the
Pre-Out is an option and will be installed
f o r s p e c i a l d e s i g n e d p r o j e c t s a n d
according to special orders only.
1. LED 1 (Orange) Wireless LED
2. LED 2 (Green) Power LED
3. LED 3 (Red) Tuner Status
4. RESET
Blinking slowly : wireless is connecting
Blinking quickly : wireless is connected
and transmitting data.
This is a Power On LED.
Tuner Initialization Confirmed
This is a switch to reset TR1a. When
TR1a experiences unstable operation or
trouble for connecting,
you can use the switch to reset TR1a by
following procedure,
a. Switch off the TR1a
b. Press and hold the reset button and
then switch on TR1a
c. Wait for 5 seconds and then release
the reset button.
d. the TR1a should have then been reset
to factory default setup.