Avocent Advanced Console Server ACS 6000 User Manual
Page 26
16 Cyclades ACS 6000 Advanced Console Server Command Reference Guide
CLI Equivalent Actions to Web Manager Checkbox Selection
NOTE: The following example procedure, which configures IPv6, illustrates the actions to use in the CLI to
enable or disable an option when a checkbox would be selected or deselected in the Web Manager.
To configure IPv6 (example of how to perform the equivalent of Web Manager
checkbox selection/deselection):
1.
Log into the CLI and enter
cd appliance_settings/network/ip
.
--:- units cli-> cd appliance_settings/network/ipv6
2.
Enter
show
to view the status of IPv6 configuration.
--:- ipv6 cli-> show
IPv6
[X] enable_IPv6
[ ] get_dns_from_dhcpv6
[ ] get_domain_from_dhcpv6
NOTE: At this location, you can use '=' to change the value or '/' to select a parameter inside the section.
3.
Type
set enable_ipv6=
and press
Tab
to view the options for the parameter.
--:- ipv6 cli-> set enable_ipv6=<
Tab>
no yes
4.
Type
set enable_ipv6:
and press
Tab
to view the child parameters.
--:- ipv6 cli-> set enable_ipv6/<
Tab>
get_dns_from_dhcpv6= get_domain_from_dhcpv6=
5.
Enter
set enable_ipv6=no
to disable IPv6.
--:- ipv6 cli-> set enable_ipv6=no
-or-
Enter
set enable_ipv6=yes
to enable IPv6.
--:- ipv6 cli-> set enable_ipv6=yes
6.
(Optional) Enter either of the following commands to enable subparameters.
**:- ipv6 cli-> set enable_ipv6/ get_dns_from_dhcpv6=yes
**:- ipv6 cli-> set enable_ipv6/ get_domain_from_dhcpv6=yes
7.
Enter
show
to verify the change.
**:- ipv6 cli-> show
ipv6
[X] enable_ipv6
[X] get_dns_from_dhcpv6