HP Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 90)

Virtual Connect networks 90
Field name Description
Smart Link (on page 71 ) Shows whether Smart Link is enabled (checked) or disabled (unchecked)
Private Network (" Private Networks " on
page 71 )
Shows whether this network is designated (checked) or not designated
(unchecked) as a private network
Enable VLAN Tunneling (" VLAN
Tunneling Support " on page 71 )
Shows whether VLAN tunneling is enabled (checked) or disabled
(unchecked)
External Uplink Ports
Use Shared Uplink Set Enables the selection of a shared uplink set to be used as the uplink port
for this network. For more information, see “Shared uplink sets and
VLAN tagging (on page 70 )."
Port Network port locations (enclosure, bay, and port numbers)
Port Role Applicable when Failover Connection Mode is selected. The port can be
designated as Primary or Secondary.
Port Status Shows the link status, link speed, and connectivity of the port. If the port
is unlinked and no connectivity exists, the cause is displayed. For more
information about possible causes, see "Port status conditions (on page
203 )."
Connector Type Displays the type of connector on the port; for example, RJ-45
Connected to If the port is connected to a switch that supports LLDP, the switch MAC
address and switch port number appear. A link is provided to obtain
more information about the far-end switch port.
PID
When selected, this option sets/clears the port identifier color as blue on
the VC E-net module to aid in the location of the specific uplink. The PID
status for the overall network also appears.
Speed/Duplex Pull-down menu to specify the speed and duplex (where applicable) of
the uplink port
Network Access Groups Displays the Network Access Groups that include this network.
The following table describes the available actions in the Edit Ethernet Network screen. Clicking another link
in the pull-down menu or left navigation tree causes current edits that have not been applied to be lost.
Task Action
Modify network color Select a color from the Color pull-down menu.
Modify network label
Type a label in the Labels field, and then press Enter. A network can have
up to 16 labels. Labels cannot contain spaces and are limited to 24
characters.
Enable or disable Smart Link on the
network being defined
Select the Smart Link checkbox.
Designate or do not designate the
network as a private network Select the Private Network checkbox.
Enable or disable VLAN tunneling Select the Enable VLAN Tunneling checkbox.
Enable or disable the network Select the Enabled checkbox.
Set a custom value for preferred link
connection speed or maximum link
connection speed
Select the Advanced Network Settings checkbox.
Add an external uplink port to the
network
Use the cascading menu to select a port, and then click Add Port.
Change the uplink interface port speed
or disable the port
Click the pull-down box under Speed/Duplex, and then select a setting.
Change the connection mode Click the down arrow in the box next to Connection Mode, and then
select Auto or Failover. For a description of these modes, see "Defining