HP StorageWorks 1200 All-in-One Storage System - Manual (Page 26)

3. Log on to the HP All-in-One Storage System with the default user name administrator and
the password hpinvent.
NOTE:
You can change the administrator name and password when you configure the server using
the “
Running the Rapid Startup Wizard ” on page 32.
4. To complete network configuration using the Rapid Startup Wizard, see
“
Configuring the server on the network ” on page 30.
IMPORTANT:
If you are using the remote browser method to access the All-in-One Management Console and Rapid
Startup Wizard, always close the remote session before closing your Internet browser. Closing the Internet
browser does not close the remote session. Failure to close your remote session impacts the limited number
of remote sessions allowed on the storage system at any given time.
Using the Remote Desktop method
Remote Desktop provides the ability for you to log onto and remotely administer your server, giving
you a method of managing it from any client. Installed for remote administration, Remote Desktop
allows only two concurrent sessions. Leaving a session running takes up one license and can affect
other users. If two sessions are running, additional users will be denied access.
To connect the HP All-in-One Storage System to a network using the Remote Desktop method
1. On the PC client, select Start > Run. At Open, type mstsc, then click OK.
2. Enter the serial number of the storage system followed by a hyphen (-) in the Computer box and
click Connect. For example: D4059ABC3433-.
NOTE:
If you are able to determine the IP address from your DHCP server, you can substitute the
IP address for the serial number and hyphen (-). For example: 192.100.0.1.
3. Log on to the HP All-in-One Storage System with the default user name administrator and
the password hpinvent.
The All-in-One Management Console and Rapid Startup Wizard start automatically.
NOTE:
You can change the administrator name and password when you configure the server using
the “
Running the Rapid Startup Wizard ” on page 32.
4. To complete network configuration using the Rapid Startup Wizard, see
“
Configuring the server on the network ” on page 30.
Installing and configuring the server 26