Layered topology, Logic board, Load – HP Integrity NonStop J-Series User Manual
Page 309: Initial discovery, Internal servernet fabrics, Ip address
See also
.
initial discovery
Discovery of a NonStop server with which the or the OSM Service Connection has had no prior
contact and for which it has no locally saved information.
See also
.
internal ServerNet
fabrics
The fabrics that link ServerNet devices within an HP NonStop™ server.
See also
internal ServerNet
X or Y fabric
The fabrics that link ServerNet devices within an HP NonStop™ server.
See also
internet protocol
(IP)
A data communications protocol that handles the routing of data through a network, which
typically consists of many different
. IP routes data between source and destination
Inventory view
One of several views of a server or supported Expand network available after system discovery
in the view pane of the
. The Inventory view is a table that lists server or
cluster components according to type, location, part number, and other attributes.
See also
.
IP address
An
. An IP address consists of two parts: a network address, which identifies
the network, and a local address, which identifies a host within a network. The network address
uniquely identifies a host within a network.
J
There are no entries for this section
K
There are no entries for this section
L
layered topology
The network topology for ServerNet clusters using the HP NonStop ServerNet Switch (model
6780). The layered topology can scale by adding cluster switch layers or zones. The layered
topology supports up to four layers and three zones.
See also
light-emitting
diode (LED)
A semiconductor device that emits light from its surface. LEDs are used as
on
and
in NonStop S-series servers.
line
The specific hardware path over which data is transmitted or received. A line can also have a
process name associated with it that identifies an input/output process (IOP) or logical device
associated with that specific hardware path.
line interface unit
(LIU)
A dual-ported unit consisting of two parts: a communications line interface processor (CLIP) and
a line interface module (LIM). An LIU can communicate with either the primary or the backup
processor, providing fault tolerance. When it is a component of the communications subsystem,
an LIU communicates with either processor through either of a pair of communications interface
units (CIUs).
link
A communications path between two entities.
load
To transfer the NonStop operating system image or a program from storage (typically disk) into
processor memory so that the operating system or program can run.
local area network
(LAN)
A network that is located in a small geographical area and provides a high-bandwidth, low-cost
medium to which low-cost nodes can be connected. One or more LANs can be connected to the
system such that the LAN users can access the system as if their workstations were connected
directly to it.
See also
ServerNet system area network (ServerNet SAN)
logic board (LB)
A printed wiring assembly (PWA) on which computer circuits (chips and wiring) are mounted.
logical device
number
A number that identifies a particular I/O device in the system. Logical device numbers are assigned
to physical I/O devices.
309