HP Designjet T1200 Printer series - Manual (Page 177)

4. Ensure the window is closed, as a strong light source near the printer during printhead
realignment can affect alignment.
5. The process takes about six minutes. Wait until the front-panel display shows the process
complete before using the printer.
NOTE: The printer prints a calibration image. Do not worry about the image. The front-panel
display shows any errors in the process.
Image Quality Maintenance menu procedure
1. Load the paper you wish to use, see Paper handling on page 31 . You can use a roll or cut sheet,
however, it must be A3 landscape or larger (420 by 297 mm).
CAUTION: Do not use transparent or semi-transparent paper to align the printheads.
2.
From the front panel, select the Image Quality Maintenance menu icon , then Align
printheads. The printer checks to see if it has enough paper to run the realignment.
3. If the loaded paper is satisfactory, the printer runs the realignment and prints a realignment
pattern. Ensure the window is closed, as a strong light source near the printer during printhead
realignment can affect alignment.
4. The process takes about five minutes. Wait until the front-panel display shows the process
complete before using the printer.
ENWW Align the printheads 169
In
k system issues